Milling relates to metal cutting with serrated rotary cutters, and differs in many respects from either planing or turning. The movement of the cutting edges can be more rapid than with tools which act continuously, because the edges are cooled during the intervals between each cut; that is, if a milling tool has twenty teeth, any single tooth or edge acts only from a fifteenth to a twentieth part of the time; and as the cutting distance or time of cutting is rarely long enough to generate much heat, the speed of such tools may be one-half greater than for turning, drilling, or planing tools. Another distinction between milling and other tools is the perfect and rigid manner in which the cutting edges are supported; they are short and blunt, besides being usually carried on short rigid mandrils. A result of this rigid support of the tools is seen in the length of the cutting edges that can be employed, which are sometimes four inches or more in length. It is true the amount of material cut away in milling is much less than the edge movement will indicate when compared with turning or planing; yet the displacing capacity of a milling machine exceeds that of either a lathe or a planing machine. Theoretically the cutting or displacing capacity of any metal or wood cutting machine, is as the length of the edges multiplied into the speed of their cutting movement; a rule which applies very uniformly in wood cutting, and also in metal cutting within certain limits; but the strains that arise in metal cutting are so great that they may exceed all means of resisting them either in the material acted upon, or in the means of supporting tools, so that the length of cutting edges is limited. In turning chilled rolls at Pittsburg, [141] tools to six inches wide are employed, and the effect produced is as the length of the edge; but the depth of the cut is slight, and the operation is only possible because of the extreme rigidity of the pieces turned, and the tools being supported without movable joints as in common lathes.

Under certain conditions a given quantity of soft iron or steel may be cut away at less expense, and with greater accuracy, by milling than by any other process.

A milling tool with twenty edges should represent as much wearing capacity as a like number of separate tools, and may be said to equal twenty duplicate tools; hence, in cutting grooves, notches, or similar work, a milling tool is equivalent to a large number of duplicate single tools, which cannot be made or set with the same truth; so that milling secures accuracy and duplication, objects which are in many cases more important than speed.

Milling, as explained, being a more rapid process than either planing or turning, it seems strange that so few machines of this kind are employed in engineering shops. This points to some difficulty to be contended with in milling, which is not altogether apparent, because economic reasons would long ago have led to a more extended use of milling processes, if the results were as profitable as the speed of cutting indicates. This is, however, not the case, except on certain kinds of material, and only for certain kinds of work.

The advantages gained by milling, as stated, are speed, duplication, and accuracy; the disadvantages are the expense of preparing tools and their perishability.

A solid milling cutter must be an accurately finished piece of work, made with more precision than can be expected in the work it is to perform. This accuracy cannot be attained by ordinary pro............